Fits two wrench sets. Fits the 10-pc SAE set plus the 10-pc metric set.
Fits stubby wrenches from 1/4 to 3/4 and 10 to 19 mm.
Sizes are permanently laser marked on the foam.
Drawer Size
12-3/16 X 19-3/8 inches
$55.50
larger image
note: tools are not included
Precision CNC-cut to fit 20 Icon wrenches:
Set WCSTS-10 (64707)
1/4
5/16
11/32
3/8
7/16
1/2
9/16
5/8
11/16
3/4
Set WCSTM-10 (64708)
10
11
12
13
14
15
16
17
18
19
This tool organizer was designed to fit two Icon stubby combination wrench sets. The SAE set is model number WCSTS-10 (64707). The metric set is WCSTM-10 (64708). The foam was designed for narrow drawers found in many US General Series 3 tool boxes. Be sure to measure your drawer because older boxes used different drawer sizes. The wrench sizes are laser marked on the foam with our C02 laser.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
12-3/16 X 19-3/8 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
11-15/16 X 18-1/2 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.