Drawing and Part Number Lookup |
Contact Us
920-569-0140
4 Nupla Hammer
KIT #189
Kits include both the tools and foam organizer.
This organizer is also available without tools: F-05383-R
Kit Description
4 Nupla Hammer Kit #189
This complete kit includes organizer insert F-05383-R, 4 Nupla Hammers, 1 Mayhew pry bar, and 6 Mayhew punches.
The tool organizer may be trimmed to fit a variety of drawer sizes. Please compare the minimum recommended size to your drawer size before ordering.
Detailed drawing: F-05383-R.pdf
Tool organizer made in USA. Tools made in USA.
1-Drawer Kit
Drawer Size
23-3/4 X 17-3/4 inches
$349.60 sale $284.60
Tools Included with Kit
This kit includes the following 11 Nupla and Mayhew tools:
16 oz ball pein (Nupla 21016)
16 oz quick change hammer (Nupla 09550)
1.5-inch red quick change tip (Nupla 15153)
1.5-inch green quick change tip (Nupla 15154)
16 oz claw hammer (Nupla 17016)
2 lb dead blow (Nupla Power Drive 10025)
12 inch pry bar, 17 inch overall (Mayhew Dominator 60144)
center punch, 3/8 X 5 inch (Mayhew #415, size 3/8)
line-up punch, 5/32 X 9 (Mayhew 22011, #466, size 5/32)
cold chisel, 1/2 X 6 (Mayhew #70, size 1/2)
pin punch, 1/8 X 4-3/4 (Mayhew #413, size 1/8)
pin punch, 5/32 X 5 (Mayhew #413, size 5/32)
pin punch, 3/16 X 5-1/4 (Mayhew #413, size 3/16)
Free shipping on all orders within the contiguous 48 US states.
Drawer Requirements
The foam insert included with this kit measures 23-3/4 X 17-3/4 inches.
It is not possible to compress the foam because the tool pockets will also squeeze closed. The foam sheet can be trimmed with a sharp knife if necessary. Contact customer service if you'd like us to modify the sheet size to your measurements.
The minimum recommended size for trimming is 20-3/8 X 14-3/16 inches. This leaves a margin of approximately 1/4-inch. Trimmed organizers are not returnable.
Designer Notes
"We designed this kit for a facility that might occasionally need to open a crate while also working on machines and fixtures. We aimed for variety, including different types of hammers and punches. We didn't include many large hammers because we wanted it to fit in a smaller bottom drawer. The pry bar and alignment punch should also come in handy for occasional work on machinery or tooling."
How Kits are Packaged and Shipped
After test fitting each kit, we remove the tools and seal them in a heavy-duty bag for shipping. We include a drawing to help place each tool back in the foam.
back to kits with hammers
back to kits with tools main page
view the full selection of foam tool organizers
