Drawing and Part Number Lookup |
Contact Us
920-569-0140
This organizer is also available without tools: F-06594-R
11 Wright Nut Driver Kit #193
This complete kit includes organizer insert F-06594-R and 11 Wright nut drivers.
The tool organizer may be trimmed to fit a variety of drawer sizes. Please compare the minimum recommended size to your drawer size before ordering.
Detailed drawing: F-06594-R.pdf
Tool organizer made in USA. Tools made in USA.
Drawer Size
11-7/8 X 17-3/4 inches
$210.80 sale $171.10
This kit includes the following 11 Wright nut drivers:
1/4 (Wright 9222)
5/16 (Wright 9224)
11/32 (Wright 9225)
3/8 (Wright 9226)
7/16 (Wright 9227)
1/2 (Wright 9228)
5mm (Wright 9238)
6mm (Wright 9240)
7mm (Wright 9241)
8mm (Wright 9242)
10mm (Wright 9244)
The foam insert included with this kit measures 11-7/8 X 17-3/4 inches.
It is not possible to compress the foam because the tool pockets will also squeeze closed. The foam sheet can be trimmed with a sharp knife if necessary. Contact customer service if you'd like us to modify the sheet size to your measurements.
The minimum recommended size for trimming is 9-15/16 X 16-5/16 inches. This leaves a margin of approximately 1/4-inch. Trimmed organizers are not returnable.
"This kit was created using the new Wright nut drivers which have a large handle design we like. Wright uses a hollow tube for clearance around long threads or bullet nose studs. These nut drivers are somewhat pricey but can be a big time saver. You'll often see nut drivers being used by electricians or technicians working on control panels on industrial equipment. Nut drivers are also useful for removing lower engine covers on some vehicles, and they are great for tightening hose clamps. "
After test fitting each kit, we remove the tools and seal them in a heavy-duty bag for shipping. We include a drawing to help place each tool back in the foam.
back to kits with screwdrivers
back to kits with tools main page
view the full selection of foam tool organizers