Contact Us |
Drawing and Part Number Lookup
920-569-0140
Foam Tool Organizer for
18 Craftsman Inch and Metric Combination Wrenches
Overview
18 Craftsman Inch and Metric Combination Wrenches
Fits (9) raised-panel, USA-made wrenches from 1/4 through 3/4, and (9) raised-panel, USA-made wrenches from 7 through 16 mm.
Caution: Only fits the older Craftsman wrenches marked "FORGED IN U.S.A." Newer Craftsman wrenches will not fit because they have larger heads and some length differences.
Drawer Size
22-1/4 X 10-5/8 inches
$41.40
Details
- Drawer size: 22-1/4 X 10-5/8 inches (inside width by inside depth)
- Standard colors: black/red, blue/yellow, black/blue
- Made from closed-cell polyethylene tool foam.
- Precision CNC-cut to fit 18 Craftsman combination wrenches:
inch sizes:
1/4, 5/16, 11/32, 3/8, 7/16, 1/2, 9/16, 5/8, 3/4 (left side)
metric wrenches:
7, 8, 10, 11, 12, 13, 14, 15, 16 (right side)
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Tool Requirements
This tool organizer was designed to fit the older raised-panel wrenches which have "FORGED IN U.S.A." markings. Wrenches lacking this mark will not fit.
Possible Modifications
Minimum trimmable size:
21-3/4 X 10-1/2 inches
Note: Trimmed organizers are not returnable.
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
Colors by special request:
black/yellow, black/green, black/gray
contact customer service to order this organizer in a special color.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F1S-00042.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
