Contact Us |
Drawing and Part Number Lookup
920-569-0140
Foam Tool Organizer for
11 Channellock Pliers Including Snap Ring Pliers
Overview
11 Channellock Pliers Including Snap Ring Pliers
Fits (11) Channellock pliers.
May be trimmed to fit a variety of drawer sizes.
Fits the newer linesman and bent nose pliers, but fits the older 6-inch long nose pliers.
Drawer Size
24 X 18 inches
$59.90
Details
- Drawer size: 24 X 18 inches (inside width by inside depth)
- Standard colors: black/red, blue/yellow, black/blue
- Made from closed-cell polyethylene tool foam.
- Precision CNC-cut to fit 11 Channellock pliers:
8.5-inch long nose pliers (Channellock 318)
8-inch bent nose pliers with cutter (Channellock E388)
6-inch long nose pliers (Channellock 326)
8-inch long reach (duckbill) pliers (Channellock 718)
7-inch cutting (diagonal) pliers (Channellock 437)
7-inch slip joint pliers (Channellock 546)
7.5-inch lineman's pliers (Channellock 367)
9.5-inch tongue and groove pliers (Channellock 420)
8-inch retaining ring pliers (Channellock 927)
9.5-inch crimping pliers (Channellock 909)
7-inch wire stripper for 10-20 AWG (Channellock 957)
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Tool Requirements
This tool organizer insert may be trimmed to fit a variety of drawer sizes. The minimum size is marked on the drawing (see link below).
Possible Modifications
Minimum trimmable size:
20-7/8 X 14-3/4 inches
Note: Trimmed organizers are not returnable.
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
Colors by special request:
black/yellow, black/green, black/gray
contact customer service to order this organizer in a special color.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F1A-01888.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
