Fits (5) inch flare nut wrenches, (6) metric flare nut wrenches.
Accommodates the flare nut wrenches from the Husky 1025-pc set H1025MTS
Drawer Size
9-1/2 X 19-3/4 inches
$36.10
larger image
note: tools are not included
Precision CNC-cut to fit 11 Husky flare nut wrenches:
inch wrenches:
1/4 X 5/16
3/8 X 7/16 (HFNW71638)
1/2 X 9/16 (HFNW91612)
5/8 X 11/16 (HFNW111658)
3/4 X 7/8
metric wrenches:
9 X 11 (HFNW911MM)
10 X 12 (HFNW1012MM)
13 X 14 (HFNW1314MM)
15 X 17
16 X 18
19 X 21
This organizer was designed to fit the flare nut wrenches from the Husky 1025-pc set H1025MTS.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
9-1/2 X 19-3/4 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
9 X 19-1/2 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.