Fits (13) metric reversible ratcheting combination wrenches
Accommodates the metric reversible ratcheting combination wrenches from the Husky 1025-pc set H1025MTS
Drawer Size
15 X 19-3/4 inches
$49.10
larger image
note: tools are not included
Precision CNC-cut to fit 13 Husky wrenches:
metric reversible ratcheting combination wrenches:
8 mm
9 mm
10 mm (HRRW10MM)
11 mm
12 mm (HRRW12MM)
13 mm (HRRW13MM)
14 mm (HRRW14MM)
15 mm (HRRW15MM)
16 mm
17 mm
18 mm
19 mm
21 mm
This organizer was designed to fit the metric reversible ratcheting combination wrenches from the Husky 1025-pc set H1025MTS.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
15 X 19-3/4 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
12-1/8 X 19-1/2 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.