Contact Us |
Drawing and Part Number Lookup
920-569-0140
Foam Tool Organizer for
113 Husky Hex and Torx Keys
Overview
113 Husky Hex and Torx Keys
Fits (23) inch hex keys, (23) metric hex keys, (9) torx keys, (18) inch folding hex keys, (16) metric folding hex keys, and (24) folding torx keys.
Accommodates the hex and torx keys from the Husky 1025-pc set H1025MTS.
Drawer Size
13-5/8 X 19-1/8 inches
$44.10
Details
- Drawer size: 13-5/8 X 19-1/8 inches (inside width by inside depth)
- Standard colors: black/red, blue/yellow, black/blue
- Made from closed-cell polyethylene tool foam.
- Precision CNC-cut to fit 113 Husky hex and torx keys:
hex keys in holders:
10-pc inch short arm (HSAHKS10PCN)
13-pc inch long arm (HLAHKS13PC)
10-pc metric short arm (HSAHKM10PCN)
13-pc metric long arm (HLAHKM13PC)
folding hex key sets:
9-pc inch (HFHKS9PC)
8-pc metric (HFHKM8PC)
9-pc mini inch (HMFHKSM17PCN)
8-pc mini metric (HMFHKSM17PCN)
torx keys:
9-pc magnetic tamper-proof torx (HLAMTXK9PC)
8-pc folding torx key set (HFTK8PC)
8-pc folding tamper-proof torx set (HFTPTK8PC)
8-pc folding mini torx set (HMFHKT8PCN)
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Tool Requirements
This tool organizer was designed to fit the hex and torx keys from the Husky 1025-pc set H1025MTS.
Possible Modifications
Minimum trimmable size:
12-11/16 X 18-3/4 inches
Note: Trimmed organizers are not returnable.
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
Colors by special request:
black/yellow, black/green, black/gray
contact customer service to order this organizer in a special color.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F-03427-R.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
