Foam Tool Organizer for
19 Icon Metric Combination Wrenches

Overview

19 Icon Metric Combination Wrenches

Fits two metric combination wrench sets. Fits 14-pc set 64709 plus 5-pc set 64803.

Fits metric wrenches from 6 to 24 mm.

Icon's anti-slip grip wrenches also fit in this organizer.

Recommended for 2-1/2 min drawer height.

Tool Notes

This tool organizer was designed to fit two Icon metric combination wrench sets. We started with the 14-pc set, then added the 5-pc large wrench set to extend the range up to 24mm. The first metric set needed is WCM-14 (64709), but the anti-slip set WCAM-14 (64712) will also fit. The large metric set is model WCM-5 (64803). The foam was designed for narrow drawers found in many US General Series 3 tool boxes. Be sure to measure the drawer because older US General boxes and other brands can be less deep in the front-to-back direction. The wrench sizes are laser marked on the foam.

Drawing

Drawing L-05860-T.pdf

Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.

Drawer Size

12-3/16 X 19-3/8 inches (inside width by inside depth)

Drawer Height

Recommended for a drawer with at least 2-1/2 inches of vertical clearance.

Minimum Trimmable Size

It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:

10-3/4 X 15-13/16 inches

Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.

Features and Benefits

• See what's missing at a glance.
• Anyone can return tools to the right spot.
• Closed-cell PE tool foam is durable and has great chemical resistance.

Standard Colors

Special Colors

We make these colors in smaller batches, but they are often in stock. Contact customer service to order.

Additional Information

Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.

The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).

Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.